Nettoyeuse builds floor scrubbers and automated cleaning vehicles for large-scale manufacturing plants in Malaysia. This page is for the people who plan floor care schedules, manage operators, and answer for downtime when a machine goes down mid-shift.
Plant floor operations
Every Nettoyeuse machine is engineered around the realities of large-scale plants: wide aisles, dense production lines, and floors that take constant abuse. These are the functions our customers rely on daily.
Machines sized for open production halls and warehouse aisles, with tank volumes and brush widths matched to shift-long operation. No mid-shift refills, no stopping to swap pads on a wet floor.
Integrated pre-sweep systems handle metal shavings, packaging offcuts, and dust that collect around presses and conveyor lines. The scrub deck stays clean, so the water stays effective.
Low-profile bumpers, rear sensors, and a clear sightline to the brush deck let operators work close to racking and machinery without constant spot checks. The machine warns before contact, not after.
Squeegee pressure and vacuum flow are tuned for the dense, polished surfaces common in Malaysian plants. Water is pulled off in one pass, leaving floors dry enough for forklift traffic immediately.
Brush decks, squeegee arms, and filter housings are reachable from the side panels. Maintenance crews can complete a full service in a single shift without lifting the machine or removing the tank.
Machines log run hours, cleaning area, and water usage per shift. Supervisors can see which zones were covered and when, without walking the floor or relying on paper logs. See how this fits into daily operations on our maintenance guide.
Floor care in heavy manufacturing is not about polish. It is about keeping production lines moving without shutdowns for cleaning. These are the concrete outcomes our machines deliver on the plant floor.
A single pass over 8,000 square meters of concrete takes under an hour with our ride-on units. Your crew starts the next shift on a dry, clean floor instead of waiting for a mop crew to finish.
Standard scrubbers clog on grinding swarf and hydraulic oil. Our brush decks and vacuum shoes are specced for the debris that actually lands on a machining floor, not a retail showroom.
One ride-on scrubber replaces three walk-behind units. That means one trained operator instead of three, and the rest of the crew stays on their assigned production tasks.
Our machines use sealed bearings and a modular brush deck that swaps in under ten minutes. Maintenance fits into your scheduled line stops, not emergency callouts at 2 a.m.
Heavy scrubbers leave a film that turns a forklift aisle into a skid risk. Our vacuum recovery pulls the water up in the same pass, so the floor is dry enough for traffic right behind the machine.